Controlled-products-systems-group 61LM Bedienungsanleitung PDF herunterladen

To prevent possible SERIOUS INJURY or

DEATH from a moving gate or garage door:

• ALWAYS keep remote controls out of

reach of children. NEVER permit children

to operate, or play with remote control

transmitters.

• Activate gate or door ONLY when it can be

seen clearly, is properly adjusted, and

there are no obstructions to door travel.

• ALWAYS keep gate or garage door in sight

until completely closed. NEVER permit

anyone to cross path of moving gate or

door.

INTRODUCTION

This product is for use with gate operators, commercial door operators and any LiftMaster

product

that uses a 390 MHz fixed code. The single-button remote control will activate one device, the

2-button remote control will activate up to 2 devices, and the 3-button remote control will activate

up to 3 devices.

Models 33LM, 33LMC,

61LM, & 61LMC

Models 62LM & 62LMC

Models 33LM, 33LMC

63LM, & 63LMC

Models 64LM & 64LMC

Locate the dip switches on your remote control

BEFORE YOU BEGIN

Single-Button and 3-Button Remote Controls:

Slide the battery cover open to access the dip

switches in the remote control.

2-Button Remote Control:

The 2-button remote control has two sets of

dip switches.

Slide the battery cover open to access the dip

switches for the smooth button. Remove the

screw on the back of the remote control and

remove the cover by pressing the tab. This will

access the dip switches for the ribbed button.

3-Button Mini Remote Control:

The large top button is recommended for use with

a garage door opener and/or light control product.

The other push buttons can be used to operate

another garage door opener and/or light control

product.

Access the dip switches by turning the remote

over and removing the back of the case. Be

careful to avoid moving circuit board components.

–

123456789

–

123456789

–

123456789

–

123456789

Tab

Single and 3-Button Remote Controls

2-Button Remote Controls

Mini Remote Controls

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - BEFORE YOU BEGIN

To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:• ALWAYS keep remote controls out of reach of children. NEVER permit ch

Seite 2 - 123 456 789

PROGRAMMING11Press and release the Smart/Learn button on your product. The LED will light.22Within 30 seconds press and hold the button on the remote

Seite 3 - “A” Smart/Learn Button

PROGRAMMING MODEL 33LM ONLYInstall the control station and receiver where the door is visible, but away from the door and its hardware. When a receive

Seite 4 - 1-800-528-9131

THE REMOTE CONTROL BATTERYTo prevent possible SERIOUS INJURY or DEATH:• NEVER allow small children near batteries.• If battery is swallowed, immediate

Seite 5 - AVERTISSEMENT

INTRODUCTIONCe produit est destiné à être utilisé avec des dispositifs de fermeture de barrières, des dispositifs de fermeture de porte commerciaux et

Seite 6 - PROGRAMMATION

Programmation avec des commutateurs dipProgrammation avec bouton intelligent/d’apprentissage11Appuyez et relâchez le bouton Intelligent/d’apprentissag

Seite 7

PROGRAMMATION DU MODÈLE 33LM UNIQUEMENTInstaller le poste de commande et le récepteur là où la porte est visible mais à l’écart de la porte et de ses

Seite 8

LES PILES DE TÉLÉCOMMANDEPour prévenir d’eventuelles BLESSURES GRAVES ou LA MORT :• Ne JAMAIS laisser de petits enfants à proximité des piles.• Aviser

Kommentare zu diesen Handbüchern

Keine Kommentare

Controlled-products-systems-group 61LM Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Sensoren Controlled-products-systems-group 61LM herunter. Controlled Products Systems Group 61LM Manuel d'utilisation Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sensoren Controlled-products-systems-group 61LM