Controlled-products-systems-group 3950 Bedienungsanleitung

Owner’s Manual Please read this manual and the enclosed safety materials carefully! The door WILL NOT CLOSE unless The Protector System® is connec

10Invisible Light BeamProtection AreaSafety Reversing Sensor6" (15 cm) max. above floorSafety Reversing Sensor6" (15 cm) max. above floorFac

11FLOOR MOUNT (RIGHT SIDE)WALL MOUNT (RIGHT SIDE)IndicatorLightSensorBracketLensExtension Bracket(See Accessories)InsideWall(Provided withExtension Br

12Invisible Light BeamProtection AreaSafety Reversing SensorBell WireBell WireMotor unitSafety Reversing SensorQuick-Connect TerminalsWHT/BLKWHTSensor

13To prevent damage to vehicles, be sure fully open door provides adequate clearance.Without a properly installed safety reversal system, persons (par

14ADJUSTMENT STEP 2Set the ForceThe force setting measures the amount of force required to open and close the door.1. Push the purple button twice to

15ADJUSTMENT STEP 3Test The Protector System®• Press the single button control station to open the door.• Place the operator carton in the path of

16OPERATION Using Your OperatorPress and hold the push button on the single button control station until the door starts to move.When the operator is

17HAVING A PROBLEM? (TROUBLESHOOTING)1. The operator doesn’t operate from either the door control or the remote control: • Does the operator have e

18Your door operator is programmed with self-diagnostic capabilities. The “Learn” button/diagnostic LED will flash a number of times then pause signif

19To Erase All Codes From Motor Unit MemoryTo deactivate any unwanted remote, first erase all codes:Press and hold the “learn” button on motor unit un

2INTRODUCTIONSafety Symbol Review and Signal Word ReviewWhen you see these Safety Symbols and Signal Words on the following pages, they will alert you

201. Press and release the purple “learn” button on motor unit. The learn indicator light will glow steadily for 30 seconds.2. Within 30 seconds, en

2167891021345NOTICEInstallation PartsREPAIR PARTS KEY PART NO. NO. DESCRIPTION 1 APBS 1 Single button control station 2 41A6298-5 Emergency

22Chain Guard:The chain guard is required to comply with UL requirements for applications where the drive chain is exposed lower than 8 feet (2.5 m).G

23NOTES

LIFTMASTER® SERVICE IS ON CALLOUR LARGE SERVICE ORGANIZATION SPANS AMERICAINSTALLATION AND SERVICE INFORMATION IS AS NEAR AS YOUR TELEPHONE.SIMPLY DIA

3Preparing Your Door Before you begin:• Remove any ropes connected to door. • Raise and lower the door to ensure the door does not bind or stick an

42-Conductor Bell WireWhite & White/RedSafety LabelsandLiteratureMounting Bracket (4)Door SprocketsThe Protector System®(2) Safety Reversing Senso

5OperatorMounting BracketsASSEMBLY STEP 1Attach the Drive SprocketThe drive sprocket can be installed on the right or left side of the operator depend

6INSTALLATIONIMPORTANT INSTALLATION INSTRUCTIONSTo reduce the risk of SEVERE INJURY or DEATH:WARNING WARNING WARNING WARNING 1. READ AND FOLLOW ALL

7INSTALLATION STEP 2Mount the OperatorThe operator can be mounted to the wall with the mounting brackets provided.An optional guide mounting bracket i

8WHT/REDWHTDoor ControlConnectionsSingle Button Control StationINSTALLATION STEP 4Install the Single Button Control Station1. Remove the control stat

9INSTALLATION STEP 5Electrical RequirementsTo avoid installation difficulties, do not run the operator at this time.To reduce the risk of electric sho