Controlled-products-systems-group 8550C-7 Bedienungsanleitung PDF herunterladen (Seite 14)

1 Install the door control

Install the Door Control

To preventpossible SERIOUS INJURY or DEATHfrom electrocution:

• Be sure power is NOTconnected BEFORE installing door control.

• Connect ONLY to 12 VOLT low voltage wires.

To preventpossible SERIOUS INJURY or DEATHfrom a closing garage door:

• Install door control within sight ofgarage door, out of reach of children at a minimum height of5 feet

(1.5 m),and away from ALL moving parts of door.

• NEVER permitchildren to operate or play with door control push buttonsor remote control

transmitters.

• Activate door ONLY when it can be seen clearly,is properly adjusted,and there are no

obstructions to door travel.

• ALWAYS keep garage door in sight until completelyclosed.NEVER permit anyone to crosspath of

closing garage door.

INTRODUCTION

Compatible with MyQ

and Security+ 2.0™

accessories, see page 37.Your garage door

opener is compatible with up to 2 Smart Control

Panels or 4 of any other Security+ 2.0™ door

controls. NOTE:Older LiftMaster door controls

and third party products are not compatible.

Install the door control within sight ofthe door at

a minimum height of 5 feet (1.5 m) where small

children cannot reach,and away from the

moving parts ofthe door.

NOTE: Your product may look different than

moving parts of the door the illustrations.

Screw

6ABx1"

HARDWARE

Drywall

Anchors

Screw

6-32x

NOTE: For gang box installations it is not necessary to drill holes or install the drywall anchors. Use the existing holes in the gang box.

1.1 Strip 7/16 inch (11 mm) of insulation from

one end of the wire and separate the wires.

7/16"

(11

mm)

1.2 Connectone wire to each of the two screws

on the back ofthe door control.The wires

can be connected to either screw.

PRE-WIREDINSTALLATIONS:Choose

any two wires to connect,note which wires

are used so the correctwires are connected

at the garage door opener in a later step.

1.3 Mark the location of the bottom mounting

hole and drill a 5/32 inch (4 mm) hole.

Wall

1.4 Install the bottom screw,allowing 1/8 inch

(3 mm) to protrude from the wall.

Screw

6-32 x

DRYWALL

GANG BOX

Screw

6AB x 1"

Drywall Anchor

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 81 82

Kommentare zu diesen Handbüchern

Keine Kommentare

Controlled-products-systems-group 8550C-7 Bedienungsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sensoren Controlled-products-systems-group 8550C-7