Controlled-products-systems-group 8550C-7 Bedienungsanleitung PDF herunterladen (Seite 19)

Install the Protector System

1 Install the Safety Reversing Sensors

OPTION C

FLOOR INSTALLATION

Use an extension bracket (notprovided) or wood block to raise the sensor bracket ifneeded.

1.1C Carefully measure the position of both

sensor bracketsso they will be the same

distance from the wall and unobstructed.

1.2C

Attach the sensor brackets to the floor

using concrete anchors (not

provided).

Insi

Garage

(not provided)

1.3C

Slide the carriage boltinto the sloton

each sensor.

Carriage Bolt

1/4" - 20 x 1/2"

1.4C

Insert the bolt through the hole in the sensor

bracketand attach with the wing nut. The lens

on both sensorsshould point toward each

other. Make sure the lensisnot obstructed by

the sensor bracket.

Wing Nut

1/4" - 20

2 Wire the Safety Reversing

Sensors

OPTION A

INSTALLATION WITHOUT PRE-WIRING

PRE-WIRED INSTALLATIONS: If your garage

already has wires installed for the safety reversing

sensors, see page 20.

HARDWARE

Insulated Staple

ot shown)

2.1A Run the wire from both sensors to the

garage door opener.Attach the wire to

the wall and ceiling with the staples.

Staple

2.2A Strip 7/16 inch (11 mm) of insulation

from each set of wires. Separate the

wires. Twist the white wires together.

Twist the white/black wires together.

7/16"

(11 mm)

2.3A Insert the white wires into the white terminal on

the garage door opener. Insert the white/black

wires into the grey terminal on the garage door

opener. To insert or remove the wires from the

terminal, push in the tab with a screwdriver tip.

RED

WHITE

GREY

RED

WHITE

GREY

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 81 82

Kommentare zu diesen Handbüchern

Keine Kommentare

Controlled-products-systems-group 8550C-7 Bedienungsanleitung Seite 19

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sensoren Controlled-products-systems-group 8550C-7